Specification

Our zinc melting furnace, with a 550 kg/hr melting rate and 2500 kg capacity (ZNMF-550-2500) is designed for zinc melting, commonly found in the automotive industry. This furnace boasts a fast 550 kg/hour melting rate with 2500 kg holding capacity. Purely using electrical power, this furnace is easy to install, without the need of any gas equipments, while also providing virtually no harmful gas emission.

Furnace Construction

• Melting Rate: 550 Kg/Hour, Holding Rate: 2500 Kg
• Inside Dimension (Approx.): Width 1240 mm x Depth 740 mm x Height 740 mm
• Outside Dimension (Approx.): Width 1940 mm x Depth 1440 mm x Height 1085 mm
• Mild steel outer shell finished by heat resistant paint
• Combination of lining with ceramic fibre board, fire Brick backed up by insulating brick, low cement and hi-alumina castable to ensure low heat loss & power consumption while maintaining a low shell temperature.
• Steel structure charging tower equipped with bucket elevator & electrical charging hoist

Heating Source

• Melting & holding chamber heat source by a deep corrugated electric heater element

Electrical Features

• Remote floor standing type electrical control panel
• PLC wired control circuit
• Microprocessor-based digital indicating temperature controller on melting exhaust, holding chamber & molten temperature control
• Full proportional heating control by SCR power regulator to enable high accuracy, fast response, and uniformity while extending heater life

Safety

• Overheat protection system

Warranty

• 1-year spare parts and services warranty (normal operation)